I use this thing for all sorts, sanding heads obviously really good, it gets into the corners when you're sanding. So the blade on the multi tool to cut my boxes out and my chases out, and made sure work of it. Try chasing that out with your SDS with hand-stop on it and a chisel, it doesn't happen. The walls are actually made of straw, unbelievable. Today of all days I went to a job on a fairly new estate, about 30 years old, and was shocked to find straw in the walls. And then recently I've started using it more and more, until most recently it's one of the staple tools. So for the longest time I never used this, it just sat in the van never getting much use. You tend to normally get them just like this, without the blades but you do get your sanding attachment to it, which you just click on there, put sandpaper on there if you like. Quite expensive, I think you can get them for less than £200 with a battery, a couple of batteries and charger, around £130 if they're on their own. I've had this bad boy for quite some time, it's the DeWalt 18 volt multi tool and it's the brush-less one so it's the newer one. And today I'm going to be talking about one of my favourite new tools. I'm Ben Curry from Electrical Innovations in Derby. I felt it could have come in slightly cheaper. I purchased it as a kit on a special with T-stak box, charger, battery and a few attachments. Over time this might become an issue and the sanding pad is shot. The reason I didn’t give the tool a five star rating is because the battery is starting to loosen in the battery casing and that’s with all of my DeWalt 18v batteries. The sander works a treat but at full speed the sandpaper starts sliding off which in turn starts wearing the sander pad. Fitting laminate flooring it’s great for cutting the bottom of door frames, cutting slots in fitted skirting boards, cutting plug boxes into plaster board walls and don’t forget cutting out the back of kitchen units to access water shutoff taps and the back of bookcases to gain access to power points. The most useful function must be the cutting blades. I have used this multi tool for around four years now, I pack it for every job I do as it’s so useful. DEWALT DCS355 XR Brushless Oscillating Multi-Tool
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |